24 poorts IVD
 |
|
De IVD (Intergrated Voice Device) is een combinatie van een 24 poort ATA en een 24 poort DSLAM. De IVD zet zowel een ADSL2/2+ signaal als een FXS signaal op de koperdraad, waardoor het niet meer noodzakelijk wordt om een modem/router met Voice over IP poorten te gebruiken aan de decentrale kant. Hierdoor vindt het management voor zowel de DSL als VoIP centraal plaats.
De IVD beschikt over 24 aansluitingen die kunnen worden gekoppeld in een stack tot 144 aansluitingen per stack. De uplink naar het internet kan plaatsvinden middels ethernet of glasvezel.
| Hardware Interface | Uplink Interface | Master | 1x or 2x IEEE802.3z 1000 BASE-LX / SX with SC connector | |
| Slave | 1x RJ-45 IEEE802.3ab 1000 BASE-T | |||
| Cascade | Master | 6x RJ-45 IEEE802.3ab 1000 BASE-T | ||
| DSL (Slave) | 24-port 50-pin RJ-21 Champ connector | |||
| POTS (Slave) | 24-port 50-pin RJ-21 Champ connector | |||
| Console Port | 1x RJ-45 | |||
| Alarm Port (Master) | 1 output alarm contact | |||
| DSL | Backward compatible to ITU-T G.992.1, G.dmt, ITU-T G.992.2 G.lite, ANSI T1.413 issue 2, ITU-T G.992.3 ADSL2, ITU-T G.992.5 ADSL2+ | |||
| Upstream 3M Annex M and Long reach DSL | ||||
| Power Management defined on G.992.3 and G.992.5 | ||||
| SELT (Single Ended Line Testing) for ADSL | ||||
| DELT (Dual End Loop Testing) for ADSL2 | ||||
| Fast Seamless Rate Adaptation (Fast SRA) | ||||
| Dying gasp | ||||
| VoIP | 24 FXS port | |||
| SIP / MGCP | ||||
| Codec G.711 , 729A, 723.1, G.726 | ||||
| VAD (Silence Suppression) & CNG | ||||
| G.168-2000 Echo Canceller, Jitter Buffer | ||||
| Packet Loss Concealment | ||||
| RFC2833-Out of Band DTMF | ||||
| Gain / Attenuation setting | ||||
| Modem Support Rate UP V.92 (for G.711 only) | ||||
| Line Polarity Reversa Generation | ||||
| QoS for Bandwidth Reservation | ||||
| Hunt Group | ||||
| Call Holding | ||||
| Call Forwarding | ||||
| Outbound Proxy | ||||
| NAT Traversal (STUN) {RFC 3489} | ||||
| Incoming Call Barring | ||||
| T.38 Fax Relay | ||||
| Hot Line | ||||
| Diagnostic Functions | Metallic Loop Test | AC Voltage | ||
| AC Current | ||||
| DC Voltage | ||||
| DC Current | ||||
| Resistance | ||||
| Capacitance | ||||
| Line Test | Normal Battery | |||
| Loop Current | ||||
| Dial Tone Testing | ||||
| Dial Digit Testing | ||||
| Ring Voltage Testing | ||||
| Phone Test | Pulse Digit Receiving Test | |||
| Low Frequency Signal Level Test | ||||
| High Frequency Signal Level Test | ||||
| Low Frequency Test | ||||
| High Frequency Test | ||||
| DTMF Tone Dialing Digit Receiving Test | ||||
| Howler Tone Test | ||||
| Ringing Test | ||||
| Multi-register | ||||
| Indicator | Master | Power, Active, Critical / Major / Minor Alarm, Subtend , MGN, UP | ||
| Slave | Power, Active, MGN, UP, Critical / Major / Minor Alarm, VoIP for link activity, DSL for link activity | |||
| Encapsulation Mode | RFC 2684 MPoA LLC / VCMUX | |||
| ATM Feature | 8 PVCs per subscriber line | |||
| End-to-end OAM loopback in I.610 | ||||
| UNI 3.1 / 4.0 PVC | ||||
| VPI (0 - 255), VCI (0 - 65535) | ||||
| Provide Incoming and Outgoing rate limit per PVC | ||||
| Bridge Feature | IEEE802.1p CoS Prioritization | |||
| IEEE802.1Q VLAN support | ||||
| IGMP Snooping and 256 multicast groups | ||||
| 802.1d STP | ||||
| GARP / GVRP | ||||
| MAC, Packet Filter and Classifier | ||||
| 4,000 MAC addresses | ||||
| Support ICMP request from VigorCMS or management tool | ||||
| DHCP Option 82 | ||||
| Port Isolation | ||||
| VPN pass-through | ||||
| PPPoE packet forwarding | ||||
| VLAN | Support 4094, concurrent 512 VLAN ID | |||
| IEEE802.1Q tagged-based | ||||
| VLAN ID mapping to PVC | ||||
| GVRP | ||||
| QoS | IEEE802.1p | |||
| 4 priority queues for multimedia application | ||||
| Configurable priority mapping for PVC and IEEE802.1p | ||||
| Multicast Feature | IGMP snooping V1, V2 defined on RFC2236 | |||
| 256 multicast groups | ||||
| 144 copies for each multicast groups | ||||
| Management | In-band or Out-of-band Single IP management | |||
| SNMP V1.0 & V2C | ||||
| SNMP MIB for RFC1213, Ethernet , RFC2662, RFC3440 and proprietary MIBs | ||||
| Standard SNMP trap report to VigorCMS or NMS | ||||
| TFTP firmware upgrade utility via VigorCMS | ||||
| Telnet server for remote management | ||||
| SNMP enabled for network management function | ||||
| Console or Telnet CLI for configuration or status monitor | ||||
| Regulatory | EN55021 classA & EN300386 V1.3.2 CE | |||
| Safety | EN60950-1 | |||
| Environment | Operating temperature : -10 °C to 65 °C (14°F to 149°F) | |||
| Non-Operating temperature : -10 °C to 85 °C (14°F to 185°F) | ||||
| Operating Humidity : 10 % to 95 % (non-condensing) | ||||
| Storage Humidity : 5% to 95% (non-condensing) | ||||
| MTBF | 55,000 hours | |||
| Power Consumption | 150W Max | |||
| Dimension | L440 * W280 * H45 (mm) | |||
| Power | AC 90 ~ 260 VAC, DC -42V ~ -60V | |||
Product-specifieke downloads
VigorAccess IVD 24 prtsMaster/slave configuratie
Door de ontwikkelde master/slave constructie van DrayTek kunnen aan elke master IVD, 6 slave IVD's worden gekoppeld. Hierdoor wordt een schaalbare infrastructuur gecreëerd die gemakkelijk te managen is. De VigorAccess slave IVD heeft 24 poorten per unit en kan door koppelingen eenvoudig worden uitgebreid tot 144 poorten. Mochten meer poorten nodig zijn dan is deze configuratie eenvoudig schaalbaar.
